Posted on

Maintaining Your Bike Chain

Chain Maintenance

Maintaining your bike chain will lengthen it’s lifespan and reduce wear and tear. The moving parts of a chain wear out with time. Dirt and sand in the chain can act like sandpaper to wear the chain out, and as the parts lose close contact, the chain extends. At the point when the chain becomes a poor fit on your chainrings and back cassette and derailleur gear-pieces, it starts wearing them out too. It can therefore be a good idea to replace your chain  on a yearly basis. It’s less expensive than a new chainset.

Maintaining your bike chain

A chain-cleaning device scours grit and sand out of the connections. Use it with a cleanser or degreasing solution. On the off chance that you ride long sessions on muddy or dusty trails and roads, the chain ought to be cleaned and re-lubed after each ride.

When you are cleaning your chain, it’s good practice to clean earth and flotsam and jetsam from the back derailleur pulleys, back gear-teeth, and chainrings with a brush. Let the chain dry, then lube. Your selection of lube relies on upon your riding type, time of year, and type of trails.

To begin, use a degreaser, as this will clean oil from the chain before reapplying lube. “Chain suck” is a feared condition where the chain clings to the base of the little or center chainring as you pedal. It wraps up around the ring until it hits the approaching chain at the highest point of the chainring, then it locks everything up, and bringing you to an unexpected stop. Keeping the chain spotless and well lubed maintains helps prevent this issue.

Depending on the volume of mud and earth your chain experiences, your chain ought to be replaced every 500-1000 miles. A chain that has extended or has side-to-side detachment must be replaced.

Here’s how to check your chain for too much wear:

While the chain is on the bike, you can put a metal ruler along the chain. Focus an inch-mark on a pin, and check whether the pins start to “tumble off” the inch mark. Measure a length of chain containing 12 external side plates. From the primary pin of plate #1 to the principal pin of plate #12 ought to quantify precisely 12 inches. (Then again, hold another chain nearby the old chain to check for stretch.)

Put sidelong weight on the chain (delicately twist it sideways, or hold it so gravity makes it droop sideways). The chain ought not have more than 2 inches of parallel hang more than 12 inches of chain.

In the event that the chain doesn’t pass both of these tests, it’s probably time to replace it.

A chain repair tool is really useful to carry with you, and is is incorporated on numerous independent bike tools.

I ordinarily pack a “quick link” in my under-seat pack, since it offers a pretty simple repair if needed. Make sure the quicklink is the correct size for your chain, as links are available for 7-or 8-speed chains (7-and 8-speed back gear-teeth utilize the same chain), and for 9-speed chains (9-speed chains are more slender). Bear in mind you’ll require a chain-breaking tool as mentioned above, to remove the old/broken link. Having this simple ability to fix a chain while out on a ride can save you from a long walk.

A spare breakaway pin link is also an option. Again, this will be particular to the size of chain you have (8-speed utilises one size; 9 speed utilises a smaller pin). This pin (along with a chain tool) lets you repair a broken chain in the event of a problem while out riding.

Check out our range of bike chain here


Leave a Reply

Your email address will not be published. Required fields are marked *